L200arg
Graduate Member
Hi all hope you can help
Just ventured down to my workshop for the first time today following my heart attack to see if everything was ok.
When I got there I noticed my lathe bed had quite a bit of surface rust on which came off quite easily when I rubbed it, but my sander and fret saw tables were ok.
So my question is, is there anything I can put on the bed to stop this happening that will still allow the tailstock and banjo to slide up and down as normal
Just ventured down to my workshop for the first time today following my heart attack to see if everything was ok.
When I got there I noticed my lathe bed had quite a bit of surface rust on which came off quite easily when I rubbed it, but my sander and fret saw tables were ok.
So my question is, is there anything I can put on the bed to stop this happening that will still allow the tailstock and banjo to slide up and down as normal