• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Oak Platers and Coasters

Vic Perrin

Vic Perrin

Moderator
Executive Member
Joined
Feb 23, 2014
Posts
8,215
Location
Rugeley Staffs
First Name
Vic
I was asked to make these for a colleague. The platters are approx 10" diam and 1" thick the coasters are 3 1/2" diam.
They were all turned using the Holdfast Vacuum Chuck.
Finished in Teak Oil.
 

Attachments

  • DSCN0462 copy.jpg
    DSCN0462 copy.jpg
    315.6 KB · Views: 49
Buckeye

Buckeye

ペンメーカー
Executive Member
Joined
Oct 15, 2013
Posts
9,697
Location
UK
First Name
Peter
They look great, should last a few years:thumbs:

Peter
 
Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,681
Location
Kent
First Name
Derek
Great job Vic as already said they should last a good while.:thumbs:

Isn't the third big one down in the right hand pile .5mm bigger than the rest:funny::funny::funny:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top