Following on from Roy's post yesterday I had a go at a piece of the rose root I've previously had a go at and shown on here. The remaining bits I've cut up at the moment have twisted and turned beyond belief and it was impossible to drill a straight line through.
I drill the holes as best as I could and on one piece a hole appeared down the side about 3/4inch long which the tube could clearly be seen when glued in. I turned the other half first to produce some shavings which I then glued into the void with ca.
I drill the holes as best as I could and on one piece a hole appeared down the side about 3/4inch long which the tube could clearly be seen when glued in. I turned the other half first to produce some shavings which I then glued into the void with ca.