Hi all need advice for dust/chip removal. I have been using an old wickes hoover that I bought many moons ago and now I am going to spend more time in the workshop making it a safer environment is on the cards.
I have a planer thicknesser a bandsaw a Router with table several benchsaws a bench sander and last but not least my lathe so basically needing something to remove chips shavings and dust I have seen one in screwfix for about £120 and a sip one in Toolstation for just under the hundred pound mark will this do the job or will I need to aim a bit higher quality wise bearing in mind this is a hobby and not my full time job?
I have a planer thicknesser a bandsaw a Router with table several benchsaws a bench sander and last but not least my lathe so basically needing something to remove chips shavings and dust I have seen one in screwfix for about £120 and a sip one in Toolstation for just under the hundred pound mark will this do the job or will I need to aim a bit higher quality wise bearing in mind this is a hobby and not my full time job?