• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

bowl

  1. apw43

    spalted beech

    evening guys After a bit of advice, I've got this 14" x 4" spalted beech blank and want to turn it into a fruit bowl which will eventually be sold to the public, is this wood ok to use for a fruit bowl? also with regards to the finish I will be using microcrystalline wax on the outside, would I...
  2. Dalboy

    Your thoughts people's

    Another day in the shed managed to finish marking out the latest project and do some shaping. I would like your thoughts on the overall idea and especially the bead on the bottom of the bowl section. There is going to be some texturing and piercing as well as colouring but that is for later. The...
  3. woodhacker

    first bowl

    Haven't turned a pen since I demolished five serpentine blanks so had a go at turning a bowl I believe the wood is sycamore (could be wrong though) will now have to figure out how to remove the holding piece on the bottom :thinks:
  4. markmcg

    Assorted pens

    Not sure where this belongs as I made 2 acrylic & 1 wooden pen & placed them in a natural-edged bowl for the pic. As there are 2 acrylic, I put the pic here. They are my first acrylic pens :-) I used wet n dry up to 2000 grade, then polished off with a brasso type polish (was in cupboard as I...
  5. B

    A part segmented Bowl with a hat

    The bowl is made of Idigbo and segmented cedar 9 1/2 inches x 12 inches high finished to 400 grit polished Danish oil then sealer then Yorkshire grit and waxed
  6. Woody

    Violets sweet bowl

    I finished yesterdays spalted beech bowl and Violet has claimed it as her sweet bowl it is 6 1/2" x 4" with a polish finish OK now Derek :face:
  7. MarkNotts

    How to transfer a flat pattern onto a curved bowl?

    Hiya I went to the UKIWS event in Coventry on Saturday and picked up a wizardry in wood magazine with incredible work in it, now i dont expect to be able to do anything like this... Redirect Notice But carving sections out of a thin walled bowl I could try, I have a dremel and some engravers...
  8. scouseroy

    my 2nd Hybrid bowl

    another Sycamore Burr and polyester resin bowl sorry the photos are not better but had to use my phone
  9. GeordieB

    Cherry Bowl

    A pain to finish but got there in the end
  10. Dalboy

    I just had to turn something

    I just had to turn something to give me my fix in the shed. so I split a blank in half and turned this ash bowl, nothing special as I said I needed to do something.
Top