• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

York 2 Part Deux!

ni9eofse7en

Registered
Joined
Jan 16, 2015
Posts
1,786
Location
Morley
First Name
John
Neil,

I know I'm being lazy, but can you post address with postcode for us sat nav boys again.

Many thanks
 

Lons

Fellow
Joined
Dec 17, 2013
Posts
4,753
Location
Northumberland
First Name
Bob
I have to leave at 4 cos have an hours drive to west of Barnard Castle for a birthday bar-be-que. I've been told by the missus to be there by 5pm or I'm in very deep doodoo. :sob: :thinks: I don't remember her saying which day though:winking:
 

GeordieB

Registered
Joined
Dec 26, 2014
Posts
2,979
Location
halifax
First Name
george
I have to leave at 4 cos have an hours drive to west of Barnard Castle for a birthday bar-be-que. I've been told by the missus to be there by 5pm or I'm in very deep doodoo. :sob: :thinks: I don't remember her saying which day though:winking:

The way you drive Bob you will make it in 30 mins :funny:
 

Neil Lawton

Longlocks
Fellow
Joined
Dec 26, 2013
Posts
3,115
Location
York
First Name
Neil
Has any one got a 1mt mandrel or dead centre, they could bring with them?

Might as well have both little lathes set up for pen turning if possible.
 

Twister

Registered
Joined
Jun 18, 2014
Posts
2,202
Location
kent
First Name
Steve
Hi Neil

what height is maximum for laser engraver ?
does it have to be shallow?

how fine will it engrave writing on wood ?
can it do circular objects?
has it got a set of basic pictures?


Steve
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top